Multitrack Recording with the Behringer X32

Before you start

Multitrack recording with the Behringer X32 usually means sending each selected input channel to a computer as a separate audio stream. The process runs locally on equipment you control: the mixer, a USB or expansion card connection, and recording software on the computer. A service or internet connection is not required for the recording itself.

Confirm that your X32 has the USB audio interface card fitted. Many consoles include this as standard, but the available channel count and connection type can depend on the installed card and firmware version. Also check that your computer can run the recording application and that the USB cable is suitable for audio use.

Step-by-step instructions

Start with the mixer and computer powered off or with the application closed. Connect the X32 to the computer using the USB port on the installed expansion card, not a USB port used only for remote control. If the card provides a different connection type, use the cable and port that match that card.

Power on the X32 first, then start the computer. Open your recording application and select the X32 or its expansion card as the audio input device. Create one track for each channel you want to record and assign the matching input number to each track.

Open the routing page on the X32 and choose the card or USB output tab. Assign a card output to the channel or direct-out signal you need. On many setups the default routing already sends channels to the computer, but check the assignments before recording so each track receives the expected source.

Set the recording tracks to monitor through the mixer or through the software, not both at the same time if that creates an echo or doubled signal. Arm the tracks for recording and use a short test pass to confirm that every channel reaches the correct track before committing to a full take.

Check the output

Play back the recorded material and compare each track with its intended input. The expected result is one continuous audio region per armed track, with the same number of recorded streams as channels you assigned. Check for silence on channels that should contain signal and activity on channels that should be quiet.

Be aware of the format and channel-count limits of the installed card and recording application. The sample rate set in the software must match the mixer or interface setting, and the available input count can be lower than the total number of X32 channels. Confirm those limits in the documentation for your exact card and firmware before assuming a channel is faulty.

Common problems and next steps

If a track records silence, first check the card output routing for that channel and the input assignment for that track. A common mistake is recording the post-fader mix or a bus output when you intended to capture the direct channel signal. Change the card output source to the direct output or channel tap point that matches your goal.

If the computer does not show the X32 as an audio device, reinstall or update the driver recommended for your operating system and card, then reconnect the cable. If the device appears but recording stops or produces errors, check the buffer size in the software and increase it in small steps until playback and recording remain stable.

When all channels are needed but not all appear, verify whether the installed card supports that input count at the current sample rate. Some configurations reduce the available channel count at higher sample rates. Lower the sample rate if the session permits it, or select a routing mode that exposes the required number of channels.